An EFI controller is the perfect way to control fuel loads with newly added exhaust or intake systems.
If you add a new exhaust system or intake system to your engine your engine flows air more efficently and with a more efficent air flow you need to also add incresed fuel to your engine as well to keep it from getting to lean.
And you dont want to run your engine lean, if you run your engine to lean it could burn up from not enough fuel.
Our system allow you to add or subtract fuel at several engine cycles, low end idle, mid range acceleration or wide open full throttle. All controllable from the program buttons on the controller.
Our EFI controller also has load based technology unlike many other controllers that just use RPM and gear position to determine fuel load. Load based technology senses engine load under various conditions to make sure the engine gets it needed fuel.
For example: An engine in third gear in soft sand needs more fuel than an engine in third gear on hard packed surfaces, our controller sences the load and adjusts the fuel curve to reflect the load on the engine not just the RPM or gear position.
It's a plug and play install that only takes about 10 minutes to put in.
The absolute best EFI controller to add power, and adjust fuel loads for new exhaust or intake systems.
FREE SHIPPING ON THIS ITEM.
This product was added to our catalog on Thursday 11 September, 2008.